Boat Name & Hailing Port Lettering

Boat name — stern, up to 36 in. $95 kit / $225 installed. The name on its own, laid out and levelled to the transom.

Boat name + hailing port. $135 kit / $295 installed. Name and port together on the stern. This is also the correct set for a USCG documented recreational vessel under 46 CFR 67.123(c) — name and hailing port together in one clearly visible place, nothing under 4 inches.

Full set — name + hailing port + STATE registration numbers. $185 kit / $395 installed. State-registered boats only. Registration numbers here means your state bow numbers — WN, ID, and the rest. A documented vessel does not display them.

Documented commercial — name x3 + hailing port on stern. $275 kit / $575 installed. For a documented vessel with a commercial endorsement: 46 CFR 67.123(a) wants the name on the port bow, the starboard bow and the stern, plus the hailing port on the stern. Four marks, three locations, nothing under 4 inches. Charter, passenger, coastwise and fishery vessels land here.

We do not cut vinyl for a USCG official number. Under 46 CFR 67.121 that number must be permanently affixed to an interior structural part of the hull in block characters not less than 3 inches. Vinyl does not satisfy it, and nobody here can sign off on an exception. Your name and hailing port under 46 CFR 67.123 are exactly what we do.

Installed — Washington and North Idaho. At your slip, on the trailer, or at the shop.

Self-Apply Kit — ships free to all 50 states. The same job in the same film, pre-masked and taped in position, with a printed step-by-step install guide. The kit price is the shipped price, printed above.

Jobs over $500 take 50% down, balance on completion. $500 and under is due on completion. Ship-only kits are paid in full before production. Free shipping on kits to all 50 states.

You get a to-scale layout proof to approve. Nothing goes on the machine until you say yes.

Prepping the application area is included. Old vinyl removal, damaged surfaces, gelcoat work and travel outside our service area are add-ons — quoted in person at the inspection, before any work starts.

If JZAC vinyl fails because of a defect in the material or a JZAC installation, we replace it. Self-apply customer installation workmanship is not covered, because we do not control surface preparation or application. Either way, if we cut it wrong, the film is defective, or it arrives damaged in transit, we recut and reship at our cost.

Everything here is cut to your specification, so it cannot be returned for a change of mind once approved artwork has been cut. Nothing is cut until you approve your proof — if we make a mistake, we fix it. Call or text 509-720-8239.

Call or text 509-720-8239, or email jzacdesigns@jzacdesigns.com.

• Cut to the published size, style, and contrast rule for that mark.
• Pre-spaced on transfer tape. Cast vinyl. One color.
• The owner and the inspector own placement and final acceptance. We own the cut.

Cut to the published size, style and contrast rule cited on this page. Placement and final acceptance are the operator's and the inspector's — see our Terms of Service, Section 4.

Install: WA & ID · Ships free nationwide · 509·720·8239